|
| VacUp |
The vacuum lifter you
can depend on |
|
Low cost method to
handle
back breaking tasks!
|
Coleman
VacUp is a tool for
lifting products with vacuum generated by a vacuum blower. A large quantity of air
produced, making the VacUp ideal for porous as well as non-porous items. Features:
> Heavy duty construction for long life
> Sturdy lift hose with a minimum 6' of travel
> Top assembly with 360° continuous
swivel
> Easily supported by overhead jib or bridge crane
> Low speed direct drive regenerative vacuum blower
> No belts or pulleys to maintain
> No adjustments necessary to handle varying loads
> Covered raise/lower handle rotates with operator's wrist
> Air port relieves residual vacuum upon load release and
facilitates
backwashing of baghead filters using compressed air |
|
Standard
Models |
| For handling cardboard
boxes, sheets, etc. |
| Model |
Capacity |
Extended
Length |
Collapsed
Length |
Hanging
Weight |
Lift Hose
Diameter |
Vacuum
Blower |
| V0805 |
100lbs. |
116" |
44" |
48lbs. |
8" |
5 hp |
| V1005 |
150lbs. |
116" |
44" |
55 lbs. |
10" |
5 hp |
| V1010 |
175lbs. |
116" |
44" |
55lbs. |
10" |
10 hp |
| V1210 |
300lbs. |
123" |
51" |
57lbs. |
12" |
10 hp |
For handling bags |
| V0805B |
75lbs. |
120" |
48" |
52lbs. |
8" |
5 hp |
| V1005B |
100lbs. |
120" |
48" |
59lbs. |
10" |
5 hp |
| V1010B |
135lbs. |
120" |
48" |
59lbs. |
10" |
10 hp |
| V1210B |
175lbs. |
127" |
55" |
61lbs. |
12" |
10 hp |
Standard round
feet are 10", 13" and 15" O.D., Standard bag foot is 9"x14"
oblong with a bag skirt and built in filters |
|
VacUp
Operation |
|
|
VacUp's vertical motion is
controlled by raising or lowering the raise/lower handle. This increases or
decreases the vacuum level in the lifting hose and regulates the load height. If the
handle is released, VacUp will maintain its position. The operator simply moves his
hand naturally up and down, and VacUp will follow, moving loads up to 300 lbs.
effortlessly. VacUp's holding
function is controlled by the Grip/release handle. To grip a load, the grip/release
handle is "tapped" downward, and it automatically springs to open the foot to
vacuum. To release the load, the grip/release handle is pulled towards the operator
with a finger or two outstretched from the raise/lower handle. This will not only
cut off the vacuum to the foot, but will also open the foot to the atmosphere, relieving
any residual vacuum found in it. It is not necessary to twist or tip the unit for
the VacUp to release it's load. |
Return
to top of the page
|
